Free Pattern: Bumble Bee Rattle

Free crochet pattern: Bumble Bee Rattle // Kristi Tullus (spire.ee) 

This chubby little bumble bee is is crocheted around a rattle made of a plastic egg from a Kinder Surprise chocolate egg filled with small glass beads. But you can always use fiberfill to stuff the body.

 

Size

About 5,5 cm (2 1/5") long, with fingering weight cotton yarn and a 1,75 mm crochet hook.

Tip! You can use the same pattern to make larger or smaller toys by using finer or bulkier yarn. Pick a crochet hook at least a size smaller than suggested on yarn label and crochet tightly enough to achieve a tight gauge that will not allow the stuffing to show through the fabric. 

 

Skills required

Crocheting in spiral
• Crocheting in rounds (optional, see below)
• Magic ring
• Single crochet stitch (double crochet stitch in UK and Australia)
Increasing
Decreasing
Finishing an open piece
Finishing a closed piece
Sewing an open piece to a closed piece
Sewing a flat piece to a closed piece 

 

You will need

• Yarn. I used fingering weight cotton yarn, 50g =125m (50g =135yd) / 4 ply / 14 wpi / 1: super fine. You will need about 10 g of yellow, 5 g of black and 7 g of white yarn.
• 1,75 - 2,25 mm crochet hook or according to the yarn.
• Plastic egg from Kinder Surprise egg and glass beads, rice etc to make a rattle. 
• Or polyester fiberfill, wool etc. for stuffing, if you do not plan to make a rattle.
• Small piece of batting (or wadding as it's called in UK and Australia).
• Cotton embroidery floss.

• Yarn needle, scissors, stitch marker.

Free amigurumi bee pattern

Abbreviations

mr, sc n = magic ring – crochet n single crochet stitches into the adjustable loop.
sc = single crochet stitch (double crochet stitch in UK and Australia).
sc n = crochet n single crochet stitches, one in each stitch.
inc = increase – crochet two single crochet stitches in the same stitch.
dec = decrease – crochet two stitches together using the invisible decrease method.
(sc 4, inc) x n = repeat the pattern between parentheses n times.
(sc 4, inc) x 6 = [36] = number of stitches in a round after finishing round.

 

Notes

• All stitches are worked into both loops, unless instructed otherwise in the pattern.
• Use a stitch marker or a piece of yarn to mark the end or the beginning of a round. Move the marker up after completing each round.

 

Stripes

• If you are using a Kinder Surprise egg for the rattle, crochet the body in spiral - joining rounds would leave a row of knots, which would show through the fabric.
• If you plan to stuff the body with fiberfill, join all rounds using the invisible join method to get perfect stripes.

 

Head & Body

With yellow yarn:

1: mr, sc 6 = [6]
2: inc x 6 = [12]
3: (sc 1, inc) x 6 = [18]
4: (inc, sc 2) x 6 = [24]
5: (sc 5, inc) x 4 = [28]
6-8: sc in each stitch = [28]

Insert the rattle inside the body and make sure it is a snug fit. You may need to increase or decrease the number of increases on round 5. Make the same number of decreases on round 17.

small crochet bee pattern 

Add a thin piece of batting inside the body and embroider the face (Tutorial: Embroidering a smile). Knot the yarn ends together inside the body.

Free crocheted bumble bee pattern 

free crocheted bee rattle pattern 

amigurumi baby toy pattern 

Change yarn, leaving both yarns attached to the body. Crochet rounds 9, 12, 15 and 18 with black yarn.

9-16: sc in each stitch = [28]

Insert the plastic egg inside the body and make sure it fits perfectly. You may need to add or skip a row single crochet stitches.

amigurumi bee 

17: (sc 5, dec) x 4 = [24]

Make the last stripe on round 18, cut the yarn and knot the yarns together.

18: (dec, sc 2) x 6 = [18] 
19: (sc 1, dec) x 6 = [12] 
20: dec x 6 = [6]

Cut the yarn, leaving a long tail, and fasten off. Pick up all the remaining stitches and close the opening.

amigurumi bee pattern

Wings (make 2)

1: mr, sc 6 = [6]
2: inc x 6 = [12]
3: (sc 1, inc) x 6 = [18]
4-7: sc in each stitch = [18]
8: (sc 1, dec) x 6 = [12] 
9: (sc 1, dec) x 4 = [8] 

Cut the yarn, leaving a long yarn tail for sewing, and fasten off. Do not stuff the wings. Flatten the wings and sew them to the body.

free amigurumi patterns

Antennae (make 2)

1: mr, sc 6 = [6]
2: (inc, sc 1) x 3 = [9]
3: sc in each stitch = [9]
4: (sc 1, dec) x 3 = [6]

Stuff the tips of the antennae firmly with batting. Do not stuff the stems.

5: dec, sc 4 = [5] 
6-8: sc in each stitch = [5] 

Cut the yarn, leaving a long yarn tail for sewing, and fasten off. Sew the antennae to the head. 

sidrunszoo patterns

Fasten and hide all yarn tails. And done!


I would love to see how your bees turn out. Post a photo to my Facebook page or leave a comment below.

 

Copyright © 2013-2016 TÜ Spire. All rights reserved.
Please do not post this pattern to your website or blog, instead post a link to http://engsidrun.spire.ee/blogs/blog1.php/free-pattern-bumble-bee-rattle. You may use this pattern as a teaching aid in any free class or e-course, or as part of a free crochet pattern, provided you credit me as the designer (Kristi Tullus, http://spire.ee).

Feel free to sell items made with this pattern. I would appreciate a credit and a link to my blog (Kristi Tullus, http://spire.ee).

Kristi Tullus

SHARE WITH FRIENDS

Facebook

Twitter

”Share

1 comment

Comment from: Christine Galindo [Visitor]
Christine Galindo

Such a cute happy little bee. Thank you for the pattern.

09/10/16 @ 17:01
jump2top